Skip to content
AP Physics 1 · Force and Translational Dynamics

Orbital mechanics

Orbital mechanics appears in 5 reviewed AP Physics 1 questions and sits in Force and Translational Dynamics. Below are worked examples showing exactly how the exam tests it, with the answer marked and every distractor explained.

How Orbital mechanics is tested

Example 1Medium
A satellite orbits Earth in a circular orbit. If the orbital radius is doubled, by what factor does the gravitational force on the satellite change?
  1. AIt stays the same, since the satellite's mass is unchanged
  2. BIt is reduced to 1/4 of the original forceCorrect
  3. CIt is reduced to 1/2 of the original force, in proportion to 1/r
  4. DIt doubles, increasing in direct proportion to the radius

Why B is right

Gravitational force follows an inverse-square law: F = GMm/r^2. Doubling r means F_new = GMm/(2r)^2 = GMm/(4r^2) = F/4, so the force is reduced to one quarter of its original value.
Why the other 3 choices miss
A
Incorrect. Gravitational force depends on the separation distance, not only on the masses, so it changes when the orbital radius changes.
C
Incorrect. This applies an inverse (not inverse-square) relationship, assuming F is proportional to 1/r rather than 1/r^2.
D
Incorrect. This assumes a direct relationship between force and radius, but gravitational force decreases as distance increases.
Example 2Harder
The gravitational potential energy of a satellite of mass m at distance r from Earth's center is U = -GMm/r. How much work must be done to move the satellite from radius R to radius 2R?
  1. AGMm/(4R)
  2. B2GMm/R
  3. CGMm/R
  4. DGMm/(2R)Correct

Why D is right

Work = Delta_U = U_final - U_initial = (-GMm/(2R)) - (-GMm/R) = -GMm/(2R) + GMm/R = GMm/R - GMm/(2R) = GMm/(2R). The work is positive because the satellite moves to higher potential energy.
Why the other 3 choices miss
A
Incorrect. This might result from an error in subtracting the fractions, such as computing 1/(2R) - 1/(4R) instead of 1/R - 1/(2R).
B
Incorrect. This is twice the PE magnitude at the surface, far exceeding the actual work needed for this orbital change.
C
Incorrect. GMm/R is the magnitude of the PE at the surface, not the change in PE between R and 2R.

Studied alongside

Other concepts from Force and Translational Dynamics.