Skip to content
ACT · Science

Chemistry

Chemistry appears in 61 reviewed ACT questions and sits in Science. Below are worked examples showing exactly how the exam tests it, with the answer marked and every distractor explained.

How Chemistry is tested

Example 1Harder
Figure 1 shows a bar chart of the mass-to-charge ratio (m/z) and relative abundance of ions detected by a mass spectrometer when analyzing an unknown compound. The x-axis shows m/z values: 12, 13, 14, 15, 16, 17, 18. The y-axis shows relative abundance (0–100%). Peaks and their heights: m/z 12 = 5%, m/z 16 = 80%, m/z 17 = 1%, m/z 18 = 100%. All other m/z values show <1% abundance. The most abundant ion (base peak, 100%) has m/z = 18 and the second most abundant has m/z = 16. The compound also shows small fragments at m/z = 12 (C+) and 15. Which compound is most consistent with this mass spectrum?
  1. ACO (carbon monoxide, molecular weight = 28)
  2. BCH4 (methane, molecular weight = 16)
  3. CH2O (water, molecular weight = 18)Correct
  4. DO2 (molecular oxygen, molecular weight = 32)

Why C is right

Water (H2O, MW = 18) would show a molecular ion peak at m/z = 18 (base peak) and a fragment at m/z = 16 (O+) from loss of 2H. Fragments at m/z = 17 (OH+) and 12 (C-containing fragments are minimal) are also consistent. The mass spectrum matches water.
Why the other 3 choices miss
A
Incorrect because CO has a molecular weight of 28; it would show a peak at m/z = 28, not 18.
B
Incorrect because methane (CH4) has a molecular weight of 16, which would give a base peak at m/z = 16, not 18 as observed.
D
Incorrect because O2 has a molecular weight of 32; it would show a base peak at m/z = 32, not 18.
Example 2Harder
Experiment 3: A student studied how the concentration of a product in a chemical equilibrium responds to changes in reactant concentration, testing Le Chatelier's Principle for the reaction: A + B ⇌ C + D. Initial [A] (mol/L) | Initial [B] (mol/L) | Equilibrium [C] (mol/L) 0.10 | 0.10 | 0.06 0.20 | 0.10 | 0.10 0.40 | 0.10 | 0.16 0.10 | 0.20 | 0.10 0.10 | 0.40 | 0.16 0.20 | 0.20 | 0.13 Based on the data, what happens to [C] at equilibrium when both [A] and [B] are doubled simultaneously?
  1. A[C] decreases because excess reactants push equilibrium backward.
  2. B[C] increases to approximately 0.13 mol/L, more than the effect of doubling either reactant alone.Correct
  3. C[C] doubles from 0.06 to 0.12 mol/L.
  4. D[C] remains unchanged because doubling both reactants cancels out.

Why B is right

Looking at the last row: when [A] = 0.20 and [B] = 0.20 (both doubled from the baseline of 0.10 each), equilibrium [C] = 0.13 mol/L. Doubling A alone gave 0.10; doubling B alone also gave 0.10; doubling both gives 0.13 — more than either alone but not additive.
Why the other 3 choices miss
A
Incorrect because Le Chatelier's Principle states that adding more reactants shifts equilibrium toward products, increasing [C], not decreasing it.
C
Incorrect because doubling both reactants gives [C] = 0.13 mol/L, not 0.12 mol/L; the relationship is not simply linear.
D
Incorrect because the data show [C] = 0.13 mol/L when both are doubled, which is higher than the baseline 0.06 mol/L.
Example 3Easier
Experiment 2: A chemistry student investigated reaction rate by measuring the time required for a fixed amount of magnesium ribbon to completely dissolve in hydrochloric acid (HCl) at different concentrations. The student kept temperature at 25°C and used the same mass of Mg in each trial. Results: HCl Concentration (mol/L) | Time to Dissolve (seconds) 0.5 | 180 1.0 | 90 1.5 | 60 2.0 | 45 2.5 | 36 As HCl concentration increases, the time for Mg to dissolve:
  1. AFirst decreases then increases, indicating an optimal concentration.
  2. BRemains unchanged, indicating concentration has no effect.
  3. CIncreases at a constant rate.
  4. DDecreases, indicating a faster reaction rate.Correct

Why D is right

As HCl concentration increases from 0.5 to 2.5 mol/L, the dissolution time decreases from 180 to 36 seconds. Less time to dissolve means the reaction is proceeding faster, so higher concentration increases reaction rate.
Why the other 3 choices miss
A
Incorrect because no increase in dissolution time is observed at higher concentrations; the time decreases monotonically.
B
Incorrect because the data clearly show a systematic decrease in dissolution time with increasing concentration.
C
Incorrect because the decrease in dissolution time is not constant — it diminishes in magnitude at each step (90, 30, 15, 9 seconds reduction), indicating a non-linear relationship.

Studied alongside

Other concepts from Science.