Skip to content

PSAT/NMSQT · technique

How to pace yourself on test day

On this page · 5 sections

The digital PSAT/NMSQT gives you 98 questions in 134 minutes, split into two sections. Reading and Writing comes first: two modules of 27 questions, 32 minutes each. After a 10-minute break, Math follows: two modules of 22 questions, 35 minutes each. Each module has its own clock in the Bluebook app. When a module's time runs out, it locks and you cannot go back to it.

Do the division once so you know your budget. Reading and Writing gives you about 71 seconds per question. Math gives you about 95 seconds per question. Those are averages, not limits, because some questions take 30 seconds and some take three minutes.

The test is adaptive by section. How you do on module 1 decides whether module 2 is the easier or the harder version, and only the harder version opens the path to the top of the score range. So module 1 accuracy matters more than module 1 speed. Each section is scored from 160 to 760, for a total of 320 to 1520. A few questions in each section are unscored trial questions, and you cannot tell which ones they are, so treat every question as real.

There is no penalty for a wrong answer. A blank can never be marked correct, but a guess might be, and a correct answer can only raise your score. Pacing on this test is therefore not about finishing fast. It is about making sure every question gets an answer, and that your minutes go to the questions where extra time actually changes the result.

The steps

  1. 1

    Know your two checkpoints before you sit down

    Memorize one pair of checkpoints per section so you never have to do math with the clock running.

    Reading and Writing (27 questions, 32 minutes): after question 10, you want about 20 minutes left. After question 20, you want about 8 minutes left. Math (22 questions, 35 minutes): after question 8, you want about 22 minutes left. After question 15, you want about 11 minutes left.

    These numbers come straight from the averages, and you should usually beat them early. Math modules run roughly from easier to harder, so the first eight questions should go faster than 95 seconds each. In Reading and Writing, questions are grouped by type, and each group runs roughly easier to harder. Glance at the timer only at your checkpoints. Checking it after every question costs focus and adds nothing.

  2. 2

    Protect module 1 accuracy

    Module 1 is the routing module, so careless errors there cost you twice. They lose the point, and they can send you to the easier module 2, which caps how high you can score.

    That changes how you spend time in module 1. Read every Reading and Writing question stem to the end before you look at the choices, because a stem asking for the "main purpose" needs a different answer than one asking for the "main idea". In Math, check what the question actually asks for. A question that asks for the value of 2x is often answered wrong by students who solve for x and stop.

    This does not mean going slowly. It means you never rush an easy question to save ten seconds. Easy questions are where the routing points are won, and losing one to a misread costs more than any time it saves.

  3. 3

    Use the two-minute rule on the first pass

    Work through the module in order. If a question passes about two minutes and you are not close to an answer, stop. Cross out choices you can rule out, pick your best guess from what is left, click Mark for Review, and move on.

    The guess matters. Bluebook does not force an answer, so a marked question with no answer stays blank if time runs out. Entering a guess first means the question is never worth zero by default. If you get back to it, you can change the answer.

    The reason for the rule is simple. You can't tell how much any one question counts, and a hard question gets no bonus for the time you put into it. Three minutes sunk into one problem is the time budget for two or three other questions. In Reading and Writing especially, a stubborn inference question can sit right before a run of quick grammar questions, so moving on often buys several fast points.

  4. 4

    Make the tools save time, not spend it

    In Math, Bluebook has a built-in Desmos graphing calculator and a reference sheet of formulas. Use Desmos where it is faster than algebra. For a system of equations, type both equations and click the intersection point. For a quadratic, graph it and read the vertex or the x-intercepts. For checking an answer, graph both sides of an equation and see where they meet.

    Do not open Desmos for arithmetic you can do in your head, or for a one-step solve. Typing takes time too.

    Practice in Bluebook before test day so the tools feel normal. The highlighter, the answer eliminator and the question navigator all work the same way on the real test. A student who first meets the Desmos panel on test day loses minutes learning it.

  5. 5

    Spend the time you banked on your marked questions

    When you reach the last question of a module, open the question navigator at the bottom of the screen. It shows which questions are answered, which are unanswered and which you marked.

    First, fix any blanks. Give every unanswered question a guess, even with three minutes left, so nothing is worth zero. Then return to your marked questions, starting with the one you felt closest to solving. A question you skipped at 2:30 because of one confusing step often clears up on a second look, because you are no longer under the pressure of the questions still ahead.

    If you change an answer, have a reason, such as a misread number or a choice you can now disprove. A vague feeling is not a reason. With about one minute left, stop working and make one last check that the navigator shows no blanks.

  6. 6

    Reset at every module break

    Each module is a fresh clock, so treat it as a fresh start. Do not spend the opening minutes of module 2 trying to guess whether it is the harder or easier version. Harder-looking questions often just mean module 1 went well, and that is good news, not bad.

    Use the 10-minute break between sections to stand up, eat a snack and drink water. Do not replay Reading and Writing questions in your head, because nothing about them can change now. Then start Math with the checkpoints from step 1 and the same two-minute rule.

Worked through

Here is one Math module 1 played out with the clock. Bluebook counts down from 35:00.

Questions 1 to 8 are mostly one- and two-step problems: a linear equation, a percent, a slope from a table. Each takes 45 to 75 seconds. At question 8 the timer reads 26:10. The checkpoint was 22 minutes, so you are about four minutes ahead. You do not slow down, but you do stop worrying.

Question 11 asks for the value of k that makes this system have no solution: 3x + ky = 7 and 6x + 10y = 5. You start eliminating variables and get tangled. At about the 90-second mark, you remember the shortcut. No solution means the lines are parallel, so the coefficients must be in the same ratio but the constants not. The second equation's x-coefficient is double the first, so 10 must be double k, which gives k = 5. Check the constants: 5 is not double 7, so the lines really are parallel and never meet. You enter 5 and move on at 22:40.

Question 14 is a word problem about a tank draining at two rates. After two minutes you still have no equation you trust. You eliminate the two choices that are bigger than the starting volume, pick the more reasonable of the two left, mark it and move on. Question 15 ends at 15:00, which is about four minutes ahead of the 11-minute checkpoint.

Questions 16 to 22 are the hardest in the module, and they take closer to the full 95 seconds each. Question 19 is a student-produced response asking where y = x^2 - 4x + 1 meets y = 2x - 7. Algebra would mean setting them equal and factoring. Instead, you type both into Desmos and click the intersections: (2, -3) and (4, 1). The question asks for the larger x-value, so you enter 4. That took about 50 seconds, which gave you extra time for the two questions after it.

You finish question 22 with 3:30 left. The navigator shows no blanks and one flag, question 14. With fresh eyes you write V = 600 - 15t for the first stage and see where you went wrong. Your guess was the wrong one of the final two, so you change it. At 1:00 you check the navigator once more, see every question answered, and let the module end.

Notice what made this work. Nothing was left blank at any point. The stuck question got a guess before you left it. The tool was used once, where it saved real time.

Common mistakes

  • Rushing module 1 to bank time. Careless errors there lose the point and can route you to the easier module 2, which limits your top score. Module 1 is where accuracy pays most.

  • Leaving a question blank. There is no penalty for wrong answers, and Bluebook will not fill in an answer for you, so a marked question with no answer earns zero. Enter a best guess before you move on, every time.

  • Fighting one hard question for four or five minutes. That is the time budget for three other questions, and no single question counts enough to be worth that trade. Guess, mark it and come back.

  • Watching the timer after every question. It breaks focus and adds anxiety without changing your pace. Check it at your two checkpoints, and let the five-minute alert cover the end.

  • Changing answers on the review pass without a concrete reason. Switch only when you find a specific error, such as a misread number or a choice you can now disprove.

  • Learning Bluebook's tools on test day. Students who have never used the built-in Desmos or the question navigator lose minutes finding them. Take at least one full practice test in the app first.

Checklist

  • I can state the time per module for both sections: 32 minutes for 27 Reading and Writing questions and 35 minutes for 22 Math questions.
  • I know my two checkpoints for each section without working them out on test day.
  • I enter a guess on every question before I mark it for review and move on.
  • I move on from any question that passes about two minutes without a clear path to the answer.
  • I read every stem to the end before I look at the choices, especially in module 1.
  • I know which Math question types are faster in Desmos, such as systems, intersections and quadratic vertices, and which are faster by hand.
  • I check the question navigator for blanks before each module's time runs out.
  • I have taken at least one full timed practice test in the Bluebook app.

More PSAT/NMSQT technique