Skip to content

AP Calculus AB · technique

How to answer the free-response section

On this page · 5 sections

Section II of AP Calculus AB gives you six free-response questions in 90 minutes. The section counts for 50 percent of your exam score. Every question is worth 9 points, so the section is 54 raw points in total.

The section comes in two parts. Part A is two questions in 30 minutes, and a graphing calculator is required. Part B is four questions in 60 minutes with no calculator. Once Part B starts, you may go back and keep working on Part A, but your calculator is put away. That works out to about 15 minutes per question across the whole section.

Each question has several lettered parts, usually (a) through (d). The questions return to the same few settings year after year. You will see rates of water or people flowing in and out, tables of values, the graph of $f'$ or $f$, particle motion along a line, and differential equations with slope fields. You will also see area and volume. Units 5 and 6, applications of derivatives and the integral, carry the most weight on the exam, and they show up in almost every question.

Readers score each question against a point-by-point rubric. Each point rewards one specific piece of work, such as a correct setup, a correct answer, or a correct justification. Your work matters as much as your answer. A bare number with no supporting work, called a bald answer, often earns no credit even when it is right. A conclusion with no reason earns nothing on a part that says "justify" or "explain." Each part is mostly scored on its own, so a wrong answer in (a) does not wreck (b). If you carry a wrong value forward and use it correctly, readers usually give you the later points.

Two rules from the directions apply to every answer. Decimal answers must be correct to three places after the decimal point, either rounded or truncated. You do not have to simplify numbers like $\tfrac{20}{3}$ or $e^2-1$. Units are different. Give units whenever a part asks you to state them. Adding correct units elsewhere, such as gallons per hour, does no harm.

The steps

  1. 1

    1. Read every part before you write

    Spend the first minute of each question reading parts (a) through (d). Underline the verb in each part, because it tells you what earns the point. "Find," "evaluate" or "approximate" wants a value with work. "Justify" or "explain" wants a reason tied to a calculus fact. "Write an expression" or "write an equation" wants a setup, and it may not need a number at all. Also circle the units and the interval, such as $0 \le t \le 8$. A question about total amount over that interval wants an integral, while a question about how fast something changes at one moment wants a derivative.

  2. 2

    2. Name the tool before you compute

    Most parts match one tool from the course, so decide which one first. "Amount at time $t$" means starting amount plus an integral of the rate, like $A(0) + \int_0^t r(x)\,dx$. A rate of change of a rate means a second derivative. An estimate from a table means a Riemann sum, a trapezoidal sum, or a difference quotient like $\frac{f(6)-f(2)}{6-2}$. A question asking whether some value must occur points to the Mean Value Theorem or the Intermediate Value Theorem. A part asking you to estimate a value near a known point wants the tangent line, $y = f(a) + f'(a)(x - a)$. A limit that gives the form $\frac{0}{0}$ or $\frac{\infty}{\infty}$ calls for L'Hospital's Rule, and you must show that form before you use the rule. Write the tool down as the first line of your work, because that line is often where the setup point lives.

  3. 3

    3. On calculator parts, write the setup, then the number

    In Part A, the calculator does the arithmetic but cannot earn the setup point for you. Write the math in standard notation, such as $\int_0^{4} (R(t) - D(t))\,dt = 13.418$. Never write calculator syntax like fnInt( or nDeriv( as your work, because readers do not accept it. The calculator is meant for four jobs: graphing, solving an equation, finding a derivative at a point, and finding a definite integral. Store every intermediate value in your calculator memory instead of retyping a rounded copy. Rounding early is a common reason a third decimal place comes out wrong.

  4. 4

    4. Justify with the function's name and the condition

    A justification must say which function does what, and why that matters. For example, state that $f'$ changes from positive to negative at $x = 3$, and then conclude that $f$ has a relative maximum at that point. Do not write "it goes from positive to negative," because readers will not guess what it means. Watch which function you are describing. If you are given the graph of $f'$, the sign of that graph tells you whether $f$ increases. A sign chart by itself is not accepted as a justification, so add a sentence. For the Intermediate Value Theorem, state first that $f$ is continuous on $[2, 6]$. For the Mean Value Theorem, state that $f$ is continuous on $[2, 6]$ and differentiable on $(2, 6)$.

  5. 5

    5. Keep every equals sign true

    Readers check that each line of your work is a true statement. Writing $3x^2 = 6x$ because you meant the derivative of $3x^2$ is $6x$ is a false equation, and it can cost a point. Use $\frac{d}{dx}$ or prime notation to show what you are doing. On a definite integral, keep the limits of integration on every line until you substitute them. If you use u-substitution, change the limits to u-values on the same line, or go back to x before you substitute. On a separable differential equation, write the $+C$ as soon as you integrate, then use the initial condition to find it before you solve for $y$. Skipping $+C$ caps your score on that part.

  6. 6

    6. Budget the clock and never leave a part blank

    Give each Part A question about 15 minutes, then move on even if you are stuck. In Part B, spend about 12 minutes on each of the four questions so you bank about 12 minutes. Use that time to return to Part A by hand, since setups still score without a calculator. If a part stumps you, write the setup anyway. An integral with correct limits and integrand often earns a point before you evaluate it. If you could not finish an earlier part, write a clearly labeled value for it, such as "using $k = 2$ from part (a)," and use it correctly. Readers often give the later points for correct work with an imported value, but this is not guaranteed.

Worked through

Here is an original no-calculator question, like one you would see in Part B, with a 9-point split typical of how these rubrics divide the work.

A particle moves along the x-axis with velocity $v(t) = t^2 - 6t + 8$ for $0 \le t \le 5$. At time $t = 0$ the particle is at $x = 2$. (a) On what open intervals is the particle moving to the left? Justify your answer. (2 points) (b) Is the speed of the particle increasing or decreasing at $t = 1$? Give a reason. (2 points) (c) Find the position of the particle at $t = 3$. (2 points) (d) Find the total distance the particle travels from $t = 0$ to $t = 5$. (3 points)

Part (a). Moving left means velocity is negative, so you solve $v(t) < 0$. Factor it as $v(t) = (t-2)(t-4)$. The velocity is zero at $t = 2$ and $t = 4$, and it is negative between them. Write the answer with the reason: the particle moves left on $2 < t < 4$ because $v(t) < 0$ there. One point is for the zeros or the sign analysis, and one point is for the interval with that reason.

Part (b). Speed increases when velocity and acceleration have the same sign, and it decreases when they have opposite signs. First find $a(t) = v'(t) = 2t - 6$. At $t = 1$, $v(1) = 1 - 6 + 8 = 3$ and $a(1) = -4$. The speed is decreasing because $v(1) > 0$ and $a(1) < 0$ have opposite signs. Saying acceleration is negative alone loses the reason point, since negative acceleration can make a particle speed up.

Part (c). Position equals the starting position plus the integral of velocity. Write $x(3) = 2 + \int_0^3 (t^2 - 6t + 8)\,dt$. The antiderivative is $\frac{t^3}{3} - 3t^2 + 8t$, which equals $9 - 27 + 24 = 6$ at $t = 3$ and $0$ at $t = 0$. So $x(3) = 2 + 6 = 8$. One point is for the integral with the initial condition, and one is for the answer. A student who reports 6 has found displacement and forgotten the starting position.

Part (d). Total distance is $\int_0^5 |v(t)|\,dt$, so you must split the integral where the particle turns around, at $t = 2$ and $t = 4$. Call the antiderivative $F(t) = \frac{t^3}{3} - 3t^2 + 8t$. Then $F(0) = 0$, $F(2) = \frac{20}{3}$, $F(4) = \frac{16}{3}$, and $F(5) = \frac{20}{3}$. The three pieces of distance are $\frac{20}{3} - 0 = \frac{20}{3}$, then $\left|\frac{16}{3} - \frac{20}{3}\right| = \frac{4}{3}$, then $\frac{20}{3} - \frac{16}{3} = \frac{4}{3}$. The total distance is $\frac{28}{3}$. One point is for the setup with absolute value or split intervals, one is for the antiderivative, and one is for the answer. Note that $\int_0^5 v(t)\,dt = \frac{20}{3}$ is the displacement, because the leftward trip cancels part of the rightward trip.

Leaving the answer as $\frac{28}{3}$ is fine, because readers do not require you to simplify. The whole response takes about 12 minutes, and every point is tied to a line a reader can find.

Common mistakes

  • Giving a bald answer on a calculator part. Writing 13.418 with no integral shown can earn zero, so always write the setup in standard notation first.

  • Rounding in the middle of a calculation. Retyping 2.31 instead of the stored value often makes the third decimal place wrong, which costs the answer point.

  • Writing vague justifications. "It is increasing" or "the graph goes up" earns nothing. Name the function and the reason, such as stating that $f'(x) > 0$ on $(1, 3)$, so $f$ is increasing there.

  • Mixing up $f$ and $f'$ when you are given a graph of the derivative. The sign of the $f'$ graph tells you where $f$ increases, and the slope of the $f'$ graph tells you the concavity of $f$.

  • Forgetting the starting amount or $+C$. Position or amount at time $t$needs the initial value plus the integral, and a separable differential equation needs $+C$ before you apply the initial condition.

  • Treating displacement as total distance. Total distance needs $\int |v(t)|\,dt$, or an integral split wherever the velocity changes sign.

  • Skipping the hypotheses of a theorem. The IVT needs $f$ continuous on $[a, b]$, and the MVT needs $f$ continuous on $[a, b]$ and differentiable on $(a, b)$.

Checklist

  • I can split 90 minutes across Part A and Part B and still save time to return to Part A.
  • I write every calculator setup in standard math notation before I give the decimal.
  • I give decimal answers correct to three places, using stored values, not rounded copies.
  • Every justification I write names the function, states the sign or condition, and links it to the conclusion.
  • I check whether a given graph is $f$ or $f'$ before I read anything off it.
  • I give units whenever a part asks me to state them.
  • I use the initial condition when finding an amount or position, and I write $+C$ immediately on a differential equation.
  • I never leave a part blank, because a setup or a carried-forward value can still earn points.

More AP Calculus AB technique